Ex-Pro D&B Distortion & Booster

in good working condition. Comes with Ninja Pedals Stickers | Fast Shipping!

The D&B is a Japanese made mosfet distortion with a built in boost. 

From Ex-Pro (translated from Japanese):

100% reproduction of picking nuances
Without using ICs and diodes, which are indispensable for conventional distortion, natural clipping by MOS-FET reproduces without spoiling the nuance of picking. Of course, like other Ex-pro products, low noise. If you turn down the guitar volume, you can get a crystal tone that doesn't seem to have passed through distortion, and you can use it without stepping on it. The booster section can be used alone or boosted after distortion.

IC unused
Normally, effects such as distortion, overdrive, and booster output through multiple stages of ICs (op amps) and diodes, but the more ICs there are, the more unrealistic the sound becomes, like a simulator. increase. D&B reproduces 100% without compromising the nuances of picking with natural clip by MOS-FET without using IC or diode. Of course, like other Ex-pro effects, low noise.

crystal tone
With conventional products, it was not possible to obtain a clear sound even if the guitar volume was turned down while the distortion was passed. With the D&B, if you turn down the guitar volume, you can get a crystal tone that doesn't seem to have passed through distortion, and you can use it without stepping on it.

booster switch
The booster section can be used alone or inserted after distortion for a boost.

mode switch
Equipped with a mode switch that can control low frequencies. All-round support for low tuning and 7-string guitar bass, as well as single and ham PU.

New mechanism battery box
A revolutionary new mechanism that inserts the 006P battery into the magazine and loads it into the main unit enables quick and reliable battery replacement. Of course, a commercially available AC adapter can also be used.D-B_photo1

tilt panel switch
The footswitch panel is set at an ergonomic 16.7 degrees for reliable switching and to prevent inadvertent movement of the volume knob or toggle switch. Furthermore, by setting the distance between the left and right footswitches to 50mm, both switches can be turned ON/OFF at the same time.D-B_photo2

True bypass switch
True bypass is a matter of course, but we also paid attention to the sound quality of the foot switch itself. Furthermore, we aimed for a true true bypass, such as using Ex-pro's original OFC single wire cable for the wiring material around the switch.